Big pole by building being covered in orange show fuses still closed, that means the truck and everything else is still energized where possible. A dangerous situation.
You have a pole with two or three 8000 volt lines... and we are getting into kilo watts in a hurry.
Not to mention both busted poles are bought and paid for once billing for total reaches the truck driver personally.
What a short circuit in this stupid trucker.
Always get out and look
Discussion in 'Questions From New Drivers' started by roadmap65, Sep 6, 2019.
Page 3 of 6
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
LoSt_AgAiN, stayinback and x1Heavy Thank this.
-
Yes you can fall through and damage whatever is below Blacktop in some situations.
Sink holes come to mind, I remember a FFE getting trapped by one as the story goes. THUMP there it sits aint going no where just yet.stayinback and D.Tibbitt Thank this. -
jammer910Z, x1Heavy, FlaSwampRat and 1 other person Thank this.
-
jammer910Z, FlaSwampRat, LoSt_AgAiN and 2 others Thank this.
-
Unfortunately the driver didn’t have any sense that the wires looked low enough to be a hazard.
“According to the National Electrical Safety Code, telephone lines must be at least 14 feet above the ground and electrical lines must be at least 15-½ feet above the ground. Sometimes, though, the lines will hang lower than the allowable minimum heights.”D.Tibbitt Thanks this. -
x1Heavy and FlaSwampRat Thank this.
-
Be safe.D.Tibbitt Thanks this. -
If that truck actually pulled those wires down, they weren't installed/maintained properly. Picture 3 shows two transformers on a three wire top pole meaning at least 480 volts. Anything over 300 volts by the NEC/IBC standard has to be mounted at a minimum of 15 feet above ground. And if you look close at picture 3, where the lines exit the transformers on the bottom it is clearly 15 feet if not more. Second is picture 1 and 2. Notice all the lines are a right angles to the truck. 90 degrees. Even the light on the pole is at 90 degrees to the truck, and the pole is bent what looks like exactly a right angle to the truck. If the truck caught a line and pulled the pole to the point it would break, it would also twist as well. Also in picture 3, the pole is leaning AWAY from the street, not toward the street as would be expected. I see no back stays on either pole, something that is required every so many feet or when a line crosses a road to prevent poles from ending up on the road or collapsing and bringing other poles down like dominoes. Now I'm not saying that truck DIDN'T pull the mess down, but if it did, there's more questions than answers as to how/why in my book.
not4hire, x1Heavy, FlaSwampRat and 1 other person Thank this. -
x1Heavy, FlaSwampRat and COBB2070 Thank this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 3 of 6