Big Loads - Post Photos Number 2

Discussion in 'Heavy Haul Trucking Forum' started by truckdad, Aug 3, 2015.

  1. Oxbow

    Oxbow Road Train Member

    12,856
    133,250
    Nov 24, 2015
    Idaho
    0
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. TripleSix

    TripleSix God of Roads

    18,541
    129,876
    Apr 10, 2009
    Copied in Hell
    0
    I went inside the restaurant and there was this old guy with hot pink hair sitting at the lunch counter that was looking for an audience and probably some breakfast sausage. Maybe he was inspired by Caitlyn winning 'woman of the year'
     
    truckdad and Heavy Hammer Thank this.
  4. Heavy Hammer

    Heavy Hammer Road Train Member

    1,184
    5,889
    May 1, 2013
    In purgatory
    0
    My wagon is in St. Louis, you coulda grabbed it and probably been back in time!
    You need to get some 12" X 12" blocks Ron, you block under the outriggers as wide as you can on your deck and then they don't rock near as bad. Even just doing one end makes a big difference.
    Unless it's local, I won't move RT's on anything but rail...even the I rail them most times.
     
    truckdad Thanks this.
  5. Pipe 40

    Pipe 40 Light Load Member

    209
    359
    Mar 24, 2012
    Toowoomba Queensland
    0
    I've seen them move over here and for some reason I keep think that I remember that the stabiliser feet were on the deck but I could be very wrong.
     
  6. skootertrashr6

    skootertrashr6 Medium Load Member

    639
    6,942
    Jan 4, 2012
    Pueblo, Co
    0
    Finally made it to WV yesterday to unload that shredder, loaded up earlier in NC heading to NE image.jpg
     
    tsavory, MJ1657, Oxbow and 2 others Thank this.
  7. passingthru69

    passingthru69 Road Train Member

    Ok, fellow heavy haulers. Tell me what's wrong with this pic.
    Ld. weighs just a little over 93k. Sorry no prize for the correct answer.More to follow after this gets answered mill roll.jpg
     
  8. truckdad

    truckdad Road Train Member

    2,033
    16,751
    Dec 14, 2014
    Penn Valley, CA
    0
    Air lines layin up in the neck by kingpin but light cord is plugged in??
     
  9. passingthru69

    passingthru69 Road Train Member

    No, not that. I have to run the air line in the main neck,due to them wanting to rub on my battery box. Light cord I run in the flip neck as it's to short to reach the main neck on these trls.
    Good eyes though.
    I will give you more of a hint. Has to do with the load, just wanted to give every one a full view pic. and maybe someone might figure out what's wrong..
     
  10. cnsper

    cnsper Road Train Member

    5,869
    27,421
    Feb 28, 2014
    0
    Where is the chain to keep it from rolling off the passenger side? Front chain is only attached to the passenger side of the trailer. Is the piece strapped on the neck part of the load?
     
  11. truckdad

    truckdad Road Train Member

    2,033
    16,751
    Dec 14, 2014
    Penn Valley, CA
    0
    My 2nd guess is 2 straps on each end aint quite enough or the fact that its not tarped. But then again, I'm a guy thats used to hauling a D-8 with a 5/16" chain tossed over the rippers. lol
     
    johndeere4020 Thanks this.
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.