c15 personality module info and fuel temp mod info

The file is for a 6NZ1-53999 serial number engine. The file has a multiple rating number and can be set up for 4 different power and rpm settings


475 hp at 1800 rpm, 1650 peak torque at 1200 rpm

475 hp at 2100 rpm, 1650 peak torque at 1200 rpm

475 hp at 1800 rpm, 1750 peat torque at 1200 rpm

475 hp at 2100 rpm, 1750 peak torque at 1200 rpm

This file allows you to choose one of these 4 hp, rpm, and torque ratings by programming the Standard Rating Number in the Customer Parameters. The Standard Rating number can be numbers 1, 2, 3, or 4 listed in the Configuration File/Customer Parameters. Most of the time they'll be programmed to 475 hp at 2100 rpm with the torque rating matching the transmission torque rating

 

the resistor mod doesnt add any noticeable power anyone who tells u it does is a liar have a '01 6nz 500 turned to a 550 with 5232 injector codes and all the plug does is make it smoke so bad the EPA will issue a warrant for ur arrest

 

This is an easy one to bump up to a much higher Hp rating with some ECM tuning

 

The wire you're talking about is on the boost sensor. The one being inquired about is on the fuel sensor and will add HP to a dyno run from 25-45 Hp depending on the fuel temperature in the tanks.

I build them and sell them, but if you do a search for it on the forum, you'll find your answer.