Cat BSX iva/injector harness replacement

Discussion in 'Heavy Duty Diesel Truck Mechanics Forum' started by Cajuncowboy654, May 26, 2020.

  1. Cajuncowboy654

    Cajuncowboy654 Light Load Member

    80
    25
    Jun 4, 2019
    0
    So I need to swap out my injector harness on my BS .

    What else do i need to buy other than the harnesses, which gaskets need to be replaced while doing the job.

    I know the valve cover seals are reusable, what about the gasket between the head and the framework that the wire harness is tied into? Is it a reusable seal or a gasket that needs to be replaced?

    Thanks
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Goodysnap

    Goodysnap Road Train Member

    1,748
    3,490
    Jul 12, 2017
    0
    Square grey rope seal on the valve cover base to the head. RTV sealant at rope joint. I always replace valve cover gaskets unless I know the age. May need some 5/16 helicoils, too....

    Get the oil seals at the harness to base too.

    I would change all oil galley plug orings on the allen plugs in the base. They get hard and brittle. Jake or oil feed bridge o-rings as well.
     
    A5¢ and pushbroom Thank this.
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  • Draft saved Draft deleted