Cheap tricks we forget to pass on...

Discussion in 'Questions From New Drivers' started by Palazon, Oct 23, 2012.

  1. Superhauler

    Superhauler TEACHER OF MEN

    12,209
    100,730
    Jan 30, 2010
    keep stroking.
    0
    also after parking sit for 15 min then pull up a couple of feet then set brakes again if there is alot of snow. that way you dont melt yourself into a hole where your tires are warm.
     
    Lilbit and chompi Thank this.
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Big Don

    Big Don "Old Fart"

    17,996
    35,643
    Sep 8, 2007
    Utah's DIXIE!
    0
    Along the same line, I was forced into stopping in a lot that was covered with a mixture of water and ice. Because I knew it was going to freeze up, I moved that truck back and forth a bit every couple of hours or so. When the interstate finally opened up, I was one of the few who could hit the road immediately. A whole bunch of trucks were frozen in solid. . .
     
    chompi, Zen Trucker and Lilbit Thank this.
  4. ironpony

    ironpony Road Train Member

    17,502
    12,015
    Sep 23, 2007
    Ask my GPS...
    0
    If you've been running through slush and puddles of water, your brakes are going to get wet. Once you get slowed down, apply light pressure while you're getting into wherever you're going to park. It'll heat-up the brakes and dry them. That'll help keep from having frozen brakes in the morning.
     
    MNdriver Thanks this.
  5. BadActor

    BadActor Light Load Member

    75
    31
    Sep 5, 2012
    0
    Boot brushes mounted on the running boards do wonders for keeping the truck floor clean, especially in the winter.
     
    davetiow and Big Don Thank this.
  6. Pmracing

    Pmracing Road Train Member

    6,354
    3,178
    Jan 28, 2011
    Arlington Heights, IL
    0
    Same thing with running in the rain on a highway or long stretches of road. Usually the brakes are a bit wet and are not at 100% efficiency.

    Mikeeee
     
  7. Busasamurai

    Busasamurai Light Load Member

    187
    148
    Oct 12, 2010
    Augusta ga
    0
    If you are having problems pulling the pins on the tandems a ratchet strap works wonders. Strap one end to the handle and one to the side of the trailer ratchet it tight now just pump trailer forward and backwards and the tension on the strap will break it loose where you can manually pull it.
     
    chompi Thanks this.
  8. mg1224

    mg1224 Light Load Member

    148
    117
    Mar 3, 2010
    Western South East
    0
    Just as an aside here, not only is doing this a good idea, not doing it is a DOT violation, and a biggie. Load securement does apply to door swingers, too. Not having your equipment secured is the same as pulling a load on a flatbed with no tiedowns. Same goes for spare tires, etc.
     
    Pmracing Thanks this.
  9. dirtyjerz

    dirtyjerz glowing beard pouty kid

    722
    360
    Jun 7, 2011
    Playing in Traffic
    0
    Very true, and bungies (rubber straps, tarp straps, whatever you wanna call em) have NO W.L.L. and are not co.sidered a form of securement.
     
  10. socal

    socal Medium Load Member

    574
    348
    Feb 18, 2008
    Los Angeles CA
    0
    If your trying to gauge your tank for fuel you can use your oil dipstick. It's long enough and always on the truck.
     
    Container Hauler and chompi Thank this.
  11. Hammer166

    Hammer166 Crusty Information Officer

    7,460
    27,046
    Aug 18, 2007
    ~8600+' and loving it!
    0


    Oh, my bad! Wrong cheap trick. :biggrin_255:
     
    Last edited by a moderator: May 9, 2015
    mustang970 Thanks this.
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.