detroit ecm wires convert freightliner to kenworth

Discussion in 'Kenworth Forum' started by gordan, Apr 28, 2011.

  1. gordan

    gordan Bobtail Member

    1
    0
    Apr 28, 2011
    forr worth tx
    0
    Hi I recent bought a rebuilt motor detroit for my kenworth.
    It seems ecm was wires going to ecm are set for freightliner. I need to convert them for kenworth. Issue is tring to get cruise control to work has not since put new motor in. Be awesome if someone had diagram of both or tips or other ideas thx.
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Bush chook

    Bush chook Light Load Member

    144
    42
    Apr 27, 2009
    Geelong
    0
    All cruise wiring is in vehicle harness wiring not engine , ddecIII and ddecIV have the same pin numbers - if you went from ddecII to ddec III or IV then you would have to change wiring harness- but you did,nt say what series engine you had , lots of things stop cruise from working - have you checked clutch and brake switch is your vss wiring hooked up to the vehicle harness
     
  4. Sparkz

    Sparkz Light Load Member

    76
    15
    Jul 10, 2011
    New Zealand
    0
    Did you get cruise to work?
     
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  • Draft saved Draft deleted