I never had to take these on or off permanently that much due to the strong type of Velcro backing used on them. But after road debris cracked my windshield good, had to get that replaced and haven't been able to get it to stay with either those 3M Velcro packs(which are probably meant for kids artwork or some thing) or those generic packs of superglue sold at most truck stops(haven't found time, or early onset Dementia causes me to forget Gorilla or Loctite when going to some place that has it).
Anywho, anyone have a surefire way to keep these units on the windshield that actually work? So far, it's a combination of the weak superglue and an old beanie scrunched up and wedged between the bottom of the PrePass and a posse-box clipboard laying on the dash. I suppose I could also see if the shop has any extra Velcro packs specific for the Prepass unit. But then I'll have to explain the glue mess on the windshield.
Gobbless.
Getting your PrePass unit to stay on windshield.
Discussion in 'Experienced Truckers' Advice' started by bentstrider83, Mar 30, 2021.
Page 1 of 4
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
-
-
-
-
Has anyone tried Alien Tape that's advertised on television?
~
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 1 of 4