Ishift clutch need be calibrated?

After I change a new clutch and cylinder. After driving one day .and everything was good .the next day when I started the truck it's Givin me a transmission sign. And no acceleration on the pedal and even I put the gear in D Truck Don go forward . Do u guys have any idea if .if truck need a software reprogramming or it's something else ?

 

I got a new clutch and new cylinder. After 1 good day driving without any issue .next day I started the truck its showing me a check transmission message and no acceleration on the pedal .when I put the gear on D truck it's not moving at all ..any ideas??

 

Depends u have to do calibration to get it moving with new clutch and cylinder it might also be something else that is going on from trans system causing this without the codes from it it's almost impossible to tell what the problem is, why was the clutch and actuator replaced.

 

They change the clutch caus when they diagnosed they found it almost on 0 .then I did changed it .and I start driving with no problem and no message on dash. After one night off duty tanks went to 0 . Then it's Giving me check transmission message .sometime no acceleration pedal sometime it's coming back after shutting off the truck .but when I put gear on D truck not moving . I called the mechanic that he fixed it he's said my be the programming wasn't good he's said it need a new software programming

 

If i would have to guess you have nothing to do with programing. probably have a different problem with transmission that y its doing this.

 

Could be wrong. But it sounds very familiar to me. Had it happen once. Transmission just died. No power nothing. Could possibly be your tecu wiring harness. Harness over the years slowly corrodes where it is connected by pins? Iirc. Needs to go to a shop. They will have to drop transmission and open it up.