mack running bad

still haven't got it back yet they called me today when they were going home to say they didn't make it to my sample today and they would have it done in the morning

kinda a moot point now, but ill post a copy of it when i get it, will be interesting anyway

 

iron was at 84ppm and soot at 88 everything else fell in normal ranges

 

ended up with 26 hours of labor, over 9k in parts, and a total bill of 13k truck seems to run pretty good now, i don't know if i ever remember it running as smooth as it does now. picked it up this evening and drove it back to my shop bobtail haven't put a load on it yet. ended up adding a few parts, 1 new unit pump 6 new injector rollers all new lifters re-mack rocker arm assembly's, had them put a new oil pump in it while it was apart as well as the cam gear balance gaskets seals, had to drop the air compressor to replace a locating pin for a injector roller that had sheered off allowing the roller to turn sideways but basically everything that was re-used during the in frame is now new, so hopefully i wont have any engine issues for quite some time.