Post flatbed load photos here V2.0

Actual scrap? Wonder why that doesn't ship in a dump bucket..

 

Not sure as the front coils had plastic on them. Maybe they split the load up once it got back to deliver. Hard telling. It was to be delivered to a place we haul the aluminum junk bales in a van to get melted down.

Sometimes its procedure to leave them banded and such as coils are a hot mess if the bands break and it unwinds. I use to work in a cast house and had to deal with that all the time.

 

Might of gone to a place that will salvage the steel. I used to haul end cuts to a place in Milwaukee that would make washers out of them

 

We do that quite a bit with high quality aluminum and titanium coils. We will pick up around ten pallets of small (3-6" wide) slitted baby coils on skids. Along with those go the edge trimmings and ends of the coils.

 

I hauled a load of scrap coils once. Went to a place that loads them in containers bound for China. It was a nightmare to tarp. Sharp edges everywhere. Plus I didn't know it was scrap so I probably sent my dispatcher about 20 pictures of all the damage. Needless to say I was pretty annoyed when I got to the consignee and found out it was scrap.

 

Do you happen to remember the name of that place?

 

Probably that place off beecher east of 94
Can't remember the name.

 

That place is Wrought Washer.

My dad has worked there for 37 years. I worked there for a year before I started driving.

 

No Dak bound in the morning.

 

Ya know when they were looking for another name for the college team, joe and a few others said why not nodak. It works,

The mighty nodak
We are nodak
This is nodak

It just works. To bad....


Sorry, stroked out there for a min..