Post your flatbed load pictures here
Discussion in 'Flatbed Trucking Forum' started by the gambler, Dec 8, 2011.
- Thread Status:
- Not open for further replies.
Page 139 of 785
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
-
My OS load going to AZ..... wound up getting the smallest load for the jobsite, seems luck has finally happened on my side for once. I added another 5/16 chain in between both the straps before i left, figured it made it look a little better to any DOT officer having a grumpy day. I also added 2 flags to the tops of each stack since the permits for one of the states said they needed flagged on the top and bottom of the widest points???
Logan76, aiwiron and The Challenger Thank this. -
Nice lookin load SHC
-
My load that I delivered this morning. A thrust reverser set for a Boeing 777. 12' wide by 9' high by 20' long each. Tomorrow morning picking up a wing that 15' wide by 58' long by 5' high going to Chine Lake Naval Warfare Center in China Lake, CA. 1190 permit routed miles and hoping to have it done in 5 to 10 days depending on our CHP escorts.
Attached Files:
The Challenger and SHC Thank this. -
-
I used to haul for a steel company, pre and post manufacturing and fabrication. -
Yeah it's prefab tank walls from Caldwell Tank. Going to a new Solar Power Plant in AZ. Nice easy load
-
Some are pretty nasty loads that I refused to drive and some where I had to go recover after it fell apart on the other driver, errr super trucker. -
It was developed in conjunction with Scania.
It was quite high revving.
It would rev to 2800 and cruise between 1800 and 2200.
It was a monster at 315hp compared to the 290 Cummins and Cats.kubotaorange76 and SHC Thank this. -
Back then you could get other brand engines in a Mack.
Is the guy in the picnic chair the one who has to hold all 4 leashes?SHC Thanks this.
Page 139 of 785
- Thread Status:
- Not open for further replies.