Removing adhered placards from shipping container

If you delivered the load, then your the placard remover. As i think i said on another thread. Make sure you are in a safe place ( at the plant or reciever). Get you some engine starting fluid. Spray placard, light it up, let it burn out, scrape off with a putty knife. Or use a small blow torch. Have used this method more times than i can remember. The torch tends to get put out by the wind, starting fluid not so much. Happy peeling!

 

Good luck getting in the rail yard with that sprayed over placards. You'll be up on a ladder scraping them off or wont be getting in.

 

Thats correct. Been known to happen.

 

Depends on carrier policy, but the majority of those I know, it's the consignee responsibility to remove, and the driver to apply

As for removing them, I carry a short handled scraper, available at any hardware store for about $19.99 and an extra blade, usually last about 5 or 6 yrs.

 

Most depot are even stricter.