Truckers Report Jobs

Find Trucking Jobs

Company Driver Company Driver Dry Van Dry Van Flatbed Flatbed Refrigerated Refrigerated Specialized Specialized Owner Operator Owner Operator
More Trucking Job Searches ⌄ Fewer Trucking Job Searches
⌃

Reset My Dash still flashes code

Discussion in 'Peterbilt Forum' started by Pauly20, Mar 9, 2014.

  1. Mar 9, 2014 #1
    Pauly20

    Pauly20 Bobtail Member

    7
    0
    Feb 8, 2014
    Jeffersonville, NY
    0
    I have a 2000 Pete with a 3406E and at first the light in the dash flashed a code 38 that the air temp intake manifold sensor was bad.. I changed that and still flashed the same code. I had to drain the system so I could fix air compressor and now its flashing 62 a low water level.. I changed that sensor also and it still flashes the 62.. Any ideas how to reset this so it clears the flashing light?

    Any help is help at this point

    Thanks in advance

    Paul
     
    Pauly20, Mar 9, 2014
    Pauly20, Mar 9, 2014
    #1
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. Mar 18, 2014 #2
    mark2014

    mark2014 Bobtail Member

    4
    0
    Jan 21, 2014
    0
    I would try to find someone with a laptop and Cat ET to try to clear out the faults.If that's not possible try disconnecting batteries for a few minutes .Honestly though getting it laptopped is the best .You may have other issues besides the two codes.
     
    mark2014, Mar 18, 2014
    mark2014, Mar 18, 2014
    #2
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.