Support Thread for the TND 500, TND 700 or future Rand McNally products. (part two)

it installed to external SD card, i am not usre what update it is on. unit will now power up

 

It is working now? I would like to remote into your computer and view the TND to make sure the files are in the right location after the update.

Preferences/general/about

Thanks,
Mark

 

I send up to RM to verify the weight restriction.

The next set of maps does have this restricted now to 58,420 lbs.

Thanks,
Mark

 

From RM GIS.


Most of it is not STAA or Truck Legal.


Thanks,
Mark

 

They are mistaken. The ban was lifted in 2010

http://www.dot.state.wy.us/WidthRestrictions/WidthRestrictions.jsp
http://www.bozemandailychronicle.co...1e8-99e0-11df-9ac2-001cc4c002e0.html?mode=jqm

 

http://www.dot.state.wy.us/WidthRestrictions/15-09Memo.pdf this is still restricted during certain months. The map data does not have the ability to put in months for restrictions.

US-191 is a long road. Is there a certain area from start/stop that you are looking at? RM is looking at the entire US-191.

Thanks,
Mark

 

I'm talking about the portion going through Yellowstone. Probably miles 0-20 or so. That seasonal restriction is on the ~50 mile section north of Utah.

 

I asked RM to look into it. They do get their data from each state. They have to go by what the State DOT shows for their roads.

Thanks,
mark

 

Note - 3450 - Some users are getting Navi.exe errors after boot up and putting in routes. RM is looking at this. I have not been able to duplicate although I am working with two users that have PM'd me about this.

I have tested for the past 5 days and I do not get the error. The developer has seen it once. Nothing shows so far in the log files.

The developer might have found one issue in the code that was difficult to find that might be causing this.

If you get this navi.exe error constantly and are on 3450 let me know and I will have you sign an NDA and put you on this "fixed" version to see if the issue has gone away with the Navi.exe error.

Thanks,
Mark

 

Bought a nearly new one from departing trucker. Intent is to use it to track mileage, fuel etc. plus trails to new sites etc. Unit has not been updated yet.. File is way too big for hot spot or wireless connection types. Timer says 22 hours and change.....like 481 files needed.

Anyway mileage tally in maintenance is not moving from original setting in maint. screen but does move on daily recap..........
Speed limits don't agree with postings either. Usually 5mph lower. This correct?

Insight? Operator error?