TND T80 has quit receiving power. Have tried three different plugs in the truck. Had this happen to previous T80. Called support center and ended up shipping unit in and getting a replacement. Both units had same issue at around 7 - 8 months after i got them.
Unit registers being plugged in but will not receive power/charge/turn on at all.
Support Thread for the TND 500, TND 700 or future Rand McNally products. (part two)
Discussion in 'Trucking Electronics, Gadgets and Software Forum' started by Mark Kling, Jul 7, 2014.
- Thread Status:
- Not open for further replies.
Page 461 of 470
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Mark I got an os update on my 80 via the launcher... is this separate from the update you’re talking about? It only shows around 550mb for the dL
-
You may get several, the OTA should run first. Then if you go to the RM Launcher after the OTA update you will see system updater, press on that again. You may get several small updates along with the Map update. These screens will now be the same looking as the OD/x40 screens for updating. No more getting the popup and pressing install.
Thanks,
Mark -
Are you plugged into the slice or the tablet?
Thanks,
Mark -
Awesome thanks gonna start now while waiting at Walmart dc I bet the update finishes before the lumpers do!!!
-
Just don't do the maps there.. it could take 5-6 hours depending on your internet speed.
-
Eh it’s there WiFi... can’t be too spectacular
-
But is already downloading
-
Have tried both.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 461 of 470
- Thread Status:
- Not open for further replies.