Suppport Thread for the TND 500, TND 700 or future Rand McNally products.

I submitted what you wrote above.

Thanks,
Mark

 

Everyone will always post what they do not like before they will post what they like. This is human nature. When was the last time you send a compliment to a company for something you liked?

Do you have a TND? If so are you having issues?

Thanks,
Mark

 

i have one for you... please tell me WHY the 710 CAN"T route me from san antonio, tx. to 665 Metts dr. lebanon, ky.......?

Their is a weight restriction, probable on the far end. I will forward to Rand to verify the restriction.

also WHY does it think that KY has toll roads.....? ky opened all the OLD toll roads over 6 years ago....!

Details?

why does it route me one way from san antonio to huntsvill, al. but not the same way back and both are longer than the way i go and i go all freeway both ways....

added to below.

does the person that wrote the base routing software understand that a VIA is not a STOP, to get the route to go the way i want "or need" i may need to add up to 5-8 via's but the 710 treats each via as a stop so as i'm going down the freeway i have to hit next STOP and loaded it also treats each via as a stop in that it shows (upper right corner) milage and arrival time to the next via NOT the milage and arrival to my next STOP...?

Rand understands this. I ran this run 3 different ways and the shortest I got was 940 Miles. If you put in the A/Z end of the route, zoom out and you will see your route. Tap the screen and place the green "+" on the spot you wish to be routed too. Zoom in till you see the road direction you need, then you should see add a Via at the bottom. Tap this and it will add it to your route.

Once in the route, if you are on the Map screen you can tap on the "cog" on the bottom left and just tap on "skip to next stop", it will recalculate from the direction you are going.

Thanks,
Mark

 

Do you have just a A/Z trip or a multi-stop for each trip?

Thanks,
Mark

 

Done,

Thanks,
Mark