Set it to 13'7". Rand found a issue in some code calculations that would not allow you under certain 13'6" bridges or tunnels. It has been fixed on the Beta side.
Thanks,
Mark
Suppport Thread for the TND 500, TND 700 or future Rand McNally products.
Discussion in 'Trucking Electronics, Gadgets and Software Forum' started by Mark Kling, Apr 16, 2010.
- Thread Status:
- Not open for further replies.
Page 256 of 756
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
This is for those that find their unit mapping them to diff directions for no reason!
I have found that the detour feature on an a to b trip is very useful, especially for a traffic backup. But I also noticed that the TND does not always remove these detours when it recalculates a new route c to d going on the same route, even though I had selected cancel detours. I had to reboot to a clean map after the detour cancel to get the tnd to route me straight across the interstate. Sometimes I would go back to the particular map section route to cancel the detour. Unit needs a cancel all detours button. Better remember your map selection detours so you can go back and cancel them! -
thanks,
Mark -
-
Thanks,
Mark -
Do ya'll feel the requirement for me to start another Thread dedicated only to features and how-to on the TND? No support - that will stay on this thread.
Just basically a landing zone for me to explain features and answer questions on how to use or find features.
Thanks,
MarkGears, SilverShadow and Raiderfanatic Thank this. -
sounds good
-
A good question.
My first thought on this is why is this information not in the user manual? -
How many people actually sit down and read the manual? It is about 140 pages.
Thanks,
Mark -
Thanks in advance for your reply!
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 256 of 756
- Thread Status:
- Not open for further replies.