No, the T5E and the T7E come with version 1652. This version had to be introducted for this models only due to firmware changes in this new production run from the factory.
Thanks,
Mark
Suppport Thread for the TND 500, TND 700 or future Rand McNally products.
Discussion in 'Trucking Electronics, Gadgets and Software Forum' started by Mark Kling, Apr 16, 2010.
- Thread Status:
- Not open for further replies.
Page 57 of 756
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
I will be at GATS doing updates and troubleshooting for you. If you are in the area be sure to bring your TND (unit only) to have it updated and checked. If you are having issues, stop by.. Hint - find me early at the booth as those at MATS can testify...
Thanks,
Mark -
Mark running from Centreville MD to Milford DE or most places in DE this 700 seems to always every time try to make it a 90 mile or more run and never seems to want to use 404 which turns it into a 42 mile run. Even from Jessup MD it tries to take you all the way back up 95 to 1 then back down instead of using 97 or 50 to make it 150 mile run instead of 70. just a little FYI
-
Thanks,
Mark -
Hi Mark
The milage for the road tax reports never seems to be enough.When does it set the milage on the gps when you cross state line or when your near the state line? -
Thanks Mark -
works fine on my truck an destination but will not work on my route and end of day -
Hi again Mark
the milage always seems to short but will check last trip and see so i can tell you what its doing
thanks Ron -
Thanks,
Mark -
Hi Mark
comparing to my odomter i have to write dome stateline crossing on trip sheets
thanks Ron
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 57 of 756
- Thread Status:
- Not open for further replies.