Suppport Thread for the TND 500, TND 700 or future Rand McNally products.

As the map data is updated then it will be reflected, only though on a map update. If it does not make the map update in time then it could be incorrect.

Thanks,
Mark

 

Since you want to Permanently set an avoid. Follow these steps.

We will use I-80 for an example.

Since you want to avoid I-80 in OH and IN, go the very end of I-80 in PA and find a city. Then Choose Destination/New Location/City Center. West Middlesex, PA is the closest I can see. Enter it in, and then at the bottom of the Begin New Route, tap on the Set Origin. This will place the TND at this location.

Now Choose Destination/New Location/City Center/Hammond, IN. Now route to this location.

On the map screen, bottom left, tap on the Cog button, tap on Detour, on the right side click on any item showing I-80. You may have to scroll down also.

Then tap on the Detour Button.

This sets a permanent detour.

Hit the back button, upper right, right side of screen, (3 arrows/lines), tap on this. At the bottom tap on Route Display Options. Tap on Highway view. You will now see I-80 is avoided in both states.

Map screen, click on the Cog (bottom left), Cancel route.

Map screen toward the bottom right, click on Return to GPS Location.

This will now physically put you back where you are.

Do this for the other Freeway you wish to avoid.

*************************

Temporary Detour.

Once in a route, map screen/right side (3 arrows/lines), tap on this. At the bottom tap on Route Display Options. Tap on Highway view. Tap on the Highway segment you wish to avoid. At the top you should see Detour. Tap on this. You should see a pop up showing what part of this Highway segment you wish to avoid. Tap on the one you wish.

Once the TND is turned off/on this Temporary Detour will have to be reset if still needed.

Thanks,
Mark

 

bump

 

Submitted internal tickets to GIS.

Thanks,
Mark