Suppport Thread for the TND 500, TND 700 or future Rand McNally products.
Discussion in 'Trucking Electronics, Gadgets and Software Forum' started by Mark Kling, Apr 16, 2010.
- Thread Status:
- Not open for further replies.
Page 692 of 756
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Sorry, should have been more specific. The program will not load, neither from the established link or from direct from the directory. When it was initially installed it would start when the unit was plugged in (ran in the background), now when you click on the link, nothing happens as if it wasn't there. And, yes, I have tried using admin priveledges.
-
Thanks,
Mark -
-
-
Mark since an update couple times back my 720 I cannot get the screen to align. It is all over the place. It started imediately after the update. I cant explain why this should've happened. I have used a stylus to place exactly on the cross but that doesn't help. It also since then when touching the screen to go to that spot if touched again will go back to the regular map loosing the zoom in.
-
Thanks mark,
for your reply and contactLast edited: Mar 1, 2014
-
Thanks,
mark -
I do use Teamviewer to remote in. If you are around High speed internet that would help. I can take a look at the Dock issue and your unit then. What is the serial number off the back of the unit?
Thanks,
mark -
Thanks,
Markdouble yellow Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 692 of 756
- Thread Status:
- Not open for further replies.