Tractor Trailer Landing Gear Crank System

Discussion in 'Questions To Truckers From The General Public' started by TmMac, Nov 6, 2022.

  1. TmMac

    TmMac Bobtail Member

    2
    0
    Nov 6, 2022
    0
    So, I need a little information about a project I am required to do.
    Specifically, I need to know the measurements of the spigot that the actual crank handle attaches to on a tractor-trailer. (Now I don't know if that's the proper name of it, but that's what I'm going with.)

    [​IMG]

    I am not sure if there's really a standard size for how big around it typically is, (1", 3/4", 1/2" etc) because there is absolutely 0 information on it. I'm not too worried about length because I've been able to find numbers for that and it seems like it ranges from around 4" - 6" (correct me if I am wrong).

    Now if there is no standard size for how large around they should be, then just knowing the largest size that one will probably encounter would also be a big help.

    Any type of help with this odd question would be extremely appreciated.
     
  2. Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  3. circle h

    circle h Light Load Member

    187
    281
    Oct 22, 2020
    0
    On my trailers they are 1 inch. I believe that they are all the same.
     
    TmMac Thanks this.
  4. TmMac

    TmMac Bobtail Member

    2
    0
    Nov 6, 2022
    0
    Thank you very much, you're a god-sent.
     
  • Truckers Report Jobs

    Trucking Jobs in 30 seconds

    Every month 400 people find a job with the help of TruckersReport.

  • Draft saved Draft deleted