Trying to avoid taking the George Washington Bridge here

Discussion in 'Experienced Truckers' Advice' started by A Bug, May 2, 2022.

  1. bigguns

    bigguns Road Train Member

    Joined:
    Jun 13, 2013
    Messages:
    2,846
    Thanks Received:
    6,854
    Location:
    Omega,GA
    0
    Along with the toll on the GWB
     
    Dave_in_AZ, bzinger, spindrift and 2 others Thank this.
  2. Trucker61016

    Trucker61016 Road Train Member

    Joined:
    Sep 18, 2017
    Messages:
    1,163
    Thanks Received:
    3,604
    Location:
    Linville, Va
    0
    Along with the 12'6 markers for snow clearance, scary for a new driver not knowing they mark everything on the expressway a foot lower when going underneath the apartments...........
     
  3. abyliks

    abyliks Road Train Member

    Joined:
    May 2, 2010
    Messages:
    3,922
    Thanks Received:
    9,173
    Location:
    ludlow MA
    0
    you can, for the one time small cost of $115….
     
    bigguns Thanks this.
  4. rbrtwbstr

    rbrtwbstr Road Train Member

    Joined:
    Jul 11, 2012
    Messages:
    3,376
    Thanks Received:
    7,794
    Location:
    in the bush somewhere
    0
    Thought they repaved the Cross Bronx recently? Haven't been there I a few years but I could've swore I read it was redone
     
    prostartom Thanks this.
  5. Elroythekid

    Elroythekid Road Train Member

    Joined:
    Sep 9, 2010
    Messages:
    2,608
    Thanks Received:
    5,663
    Location:
    Halifax Nova Scotia
    0
    If your below exit 10 take the 287 and depending where your going 87 to 84 or 684 to 84.
     
  6. prostartom

    prostartom Light Load Member

    Joined:
    Jun 20, 2014
    Messages:
    216
    Thanks Received:
    466
    0
    Yes the cross Bronx is mostly smooth now with the exception of some whoops in the left lane around exit 2. I make sure to avoid those because it will cause your cargo to do flips if you hit them fast enough. Also got to watch out for the 4wheelers gunning up the on ramps.

    They also fixed all the huge holes on the bridge itself. Now they have a huge steel plate all the way across the Northbound side on the NY side. Dam thing is over an inch thick and is basically a speed bump.
     
    Trucker61016 Thanks this.
  7. Brandonpdx

    Brandonpdx Road Train Member

    Joined:
    Dec 27, 2007
    Messages:
    4,283
    Thanks Received:
    4,119
    Location:
    Elkhart, IN
    0
    9W used to be a common cut-through for trucks trying to dodge the GW and NYC, but they shut that down back in the 80’s sometime by making it a restricted route for trucks up on the New York side. Occassionally I’d have to go up 9W on the Jersey side to get to a shipper in Northvale, but if I was trying to bypass NYC to get north I’d go 80 west to 17 north and pick up 287 over the Tappan Zee. And if you catch the Tappan Zee at off peak hours the toll is even less.
     
    Trucker61016 Thanks this.
  8. spindrift

    spindrift Road Train Member

    Joined:
    Dec 2, 2014
    Messages:
    3,233
    Thanks Received:
    12,905
    Location:
    Texas
    0
    Within the past couple months I've run to CT twice. Both times took the Tap just after morning rush hour and ran over to 95. Some slow traffic at times but overall, for that area, not too bad.
     
  9. Redtwin

    Redtwin Road Train Member

    Joined:
    Aug 17, 2012
    Messages:
    5,488
    Thanks Received:
    7,609
    Location:
    PBC, FL
    0
    That's my preferred route. BTW it's now called Gov Mario Cuomo bridge incase you were trying to find it on the map.
     
    Trucker61016 and bigguns Thank this.
  10. Brettj3876

    Brettj3876 Road Train Member

    Joined:
    Nov 18, 2014
    Messages:
    11,257
    Thanks Received:
    54,058
    Location:
    Land of local
    0
    Mine too. Coming back out of the city going back up to Binghamton if traffic was super heavy on 80 I'd run up 17 catch the thruway and run up NY17 back to Bing. A little bit longer but way better than fighting traffic all the way home
     
    Dave_in_AZ and Redtwin Thank this.