What if it Snows?

Bringing an RGN. Will need the large size.

 

@JolliRoger beat me to the correction......serves me right for putting down my phone in order to do my job.

But also, Del Shannon, Del Ray, and the Del Fuegos.

 

Yall fuss, but some of those connecters have more pins than the typical 2 blades and round ground. Even a 10 pin one requires some smarts.

 

I used to like the taco salads there. Hadn’t been in a while

 

And.....The Del Tones

 

Ah, youth. You guys should have tried an old IH combine or hay press. And fittings, think 25 or more. And some in hard to reach places.
Worst part was doing the job properly. Rag in left hand, g/gun in right (no hose/straight tube), find the fitting, wipe it clean with rag, position, connect and apply till the grease just cracks the exterior of its holder. (Few sealed and if so, seal been gone.) Do not waste grease by pumping it thru the bearing to fall on the ground. Then wipe the very litttle grease from disconnecting off the fitting. Usually could reach 3 or more from one position.
Did this, fueling/oil check the engine, remove any debris hanging on not supposed to be there, while the "dew" got off so could go to work....





.......

 

Kinda stiff on the credit up charge there.

 

Did you find the culprit that damaged it ?

 

So after mowing it's time for some good backyard fun. Y'all just hook up the UTV & a HELMET.