Glad hand seals sticking together.
Discussion in 'Experienced Truckers' Advice' started by MACK E-6, Jul 23, 2021.
Page 4 of 6
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
Try putting the grommets in backwards. With the thinner, wider part of the flange on the inside of the hole. It takes a bit of fannagling, but you should still get a good seal and they may stay in better.
I have tried this a few times and it seems to work...RocketScott and MACK E-6 Thank this. -
I actually looked in the parts room to see which manufacturer it was because we have been having this happen a lot lately. Now I forget which one it was. Going to look again on Monday. Never had this happen before Over the years.
MACK E-6 Thanks this. -
Lubriplate.
BigBob410 and God prefers Diesels Thank this. -
BigBob410, snowlauncher and MACK E-6 Thank this.
-
BigBob410, snowlauncher, slow.rider and 1 other person Thank this.
-
-
Talc
tscottme, BigBob410, blairandgretchen and 1 other person Thank this. -
I have that happen , never had it before, most of the time they won't fall out of the glad hand. Chinese are not very good at making glad hands , never had them break, now they break
-
best i can suggest is a light spray coating of maybe PAM cooking spray, as oils, lubes maybe eat away the rubber.MACK E-6 Thanks this.
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 4 of 6