Pic 3. Clean up flywheel magnets and coil bracket with fine emery cloth, then reset gap with any non embossed business card, (Farm boys 30 thousandths.)
Pic 4. Remove tank, empty. Drop in 3 or 4 solid small rocks (or teeny balls from b/bearing), add 1/3 amount of gas and shake/contort, tap edges against some solid subface) loosens rust and other crud, rinse out with gas twice....
Pic 5. Discard sponge filter. wash out with gas, oil new with 30W, well squeezed.
Pic 6. Check number on plug, look up proper plug, obtain proper plug, set gap on 30 ths, toss old plug.
(Lay over on one side. Stick a screwdriver in plug hole, hand turn with blade to bottom piston, spray a few shots of WD40 in to lube the rings coming up.)
More to do: Change oil, sharpen and balance blade.
(Line up a kid in neighborhood to use when running,)
What if it Snows?
Discussion in 'Questions From New Drivers' started by Dave_in_AZ, Mar 19, 2018.
Page 19066 of 23348
-
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
-
-
-
tramm01, hope not dumb twucker, IH9300SBA and 10 others Thank this.
-
These don't clog up in wet grass,
tramm01, MAMservices, 4mer trucker and 10 others Thank this. -
-
Back then the architect said "hey we are on a budget, make the dock 13'7 and not an inch higher.
12 down, two left to deliver then it's lunch time. Happy Monday to everyone on WIIS.Opus, 4mer trucker, hope not dumb twucker and 13 others Thank this. -
-
Trucking Jobs in 30 seconds
Every month 400 people find a job with the help of TruckersReport.
Page 19066 of 23348