I know a way to make all truckers pull up after fueling

Why spend quite a few bucks on a lock? A metric-sized nut and bolt works real nice. I imagine most don't carry metric tools. And in the case of most mega drivers, most probably don't carry any tools. As a plus, bolt cutters won't work too well either. And, yes, I know its not foolproof, but it is effective. Soooo, next time you're home, stop by the local hardware store and pick up a couple.

 

Use a 6mm bolt since they have a 10mm head. 3/8" wrench is just too small to actually fit the bolt. Or even better, use a bolt with a 12mm head. Too big for 7/16 and too small for 1/2".

 

He was probably making you wait on "his 30 minute break".Had a "clown" do that today.Ok,so I pull up "tired from chaining".Theres some pump nozzles in the tanks,but no one around? Here he comes 8 minutes later! Yes,nozzles in tanks,but not pumping.Oh,he was sitting in cab. OH,now hes ready to squeeze the triggers.Oh,NOW the 1mph pull forward.YEP,electronic logs,milking it.

 

REPLYING TO MY OWN REPLY: YES,He got a Maximum width FORTRESS PADLOCK ON HIS DOOR! Very much bolt cutter resistant.

 

It's likely not common sense they lack. It's common decency

 

A few months ago a driver click mbed back into his truck at Johnson's Corner and did not notice the nozzle fell out of the passenger tank and he pumped over 100 gallons of fuel onto the ground. Stay outside your truck and pay attention.