Magnum ltd - fargo, nd

Pete has all parts to put truck back together. FYI all drivers. Keep a eye on back Axel drive shaft. While talking to service manager, I learned that the alignment could be off and cause the u joints to run hot causing the grease to liquidfly and spin out. If you develop a vibration have it looked at.

 

What's the preferred route most ya'll use between Ft. Collins and Moorehead MN? I looked at what routes I would take, but I'm always open to an alternate route. I tried the routing wizard on Magnum's website, but it can't find Ft. Collins, Aurora or Denver in it's database.

 

I haven't done that one, but make sure you stick to i25 and us highways going thru eastern Wyoming. State highways over there have a tendency to turn to dirt.

 

Get thru Wyoming quickly... we have a 1, two punch of snow and wind rolling in starting friday morning.

 

One way is up 25 then us routes into SD, the other is 80 across Nebraska to Grand Island, then north and northeast into SD.

 

Here's the most popular route

http://www.thetruckersreport.com/tr...gnum-ltd-fargo-nd.266917/page-73#post-4696118

 

Didn't see anything there heading up from CO to Fargo

 

Post #730

 

Just scrolling down and you'll see it...

 

The link sent me to page 73...the directions ended up being on page 37...at least on my phone...I have it set for more entries per page I guess. But either way, thanks